top of page

SAE Grooved Face

0next.png
SAE Groove Face

Perfect sealing in your system

Designed with a groove seat to hold the O-ring in place during connection. The O-ring seal is placed on the O-ring groove seat and compressed during the bolt tightening process.

SAE Blind Groove Face

The tightening of bolts pulls the flat side and O-ring side together to form a seal.

Annular (circumferential) tool marks up to a surface irregular roughness value of ISO 1302-MRR Ramax 3.2 µm are acceptable.

SAE Groove Face GA Drawing

Apply in high-temperature installation

Suitable to apply in both high and low temperatures.

A rubber O-ring material made from Buna 90 shore (NBR) and Viton 90 shore is used to connect two surfaces.

It is made of a rubber material and is mostly used to seal two working surfaces.

SAE Blind Groove Flange

Temperature Rating

Flange Material

ST52.3

​

O-ring Material

NBR

​

Overall Working

Temperature

-34°C to +120°C

Flange Material

ST52.3

​

O-ring Material

VITON

​

Overall Working

Temperature

-26°C to +120°C

Flange Material

SS316

​

O-ring Material

NBR

​

Overall Working

Temperature

-34°C to +50°C

Flange Material

SS316

​

O-ring Material

VITON

​

Overall Working

Temperature

-26°C to +50°C

SAE Groove Face

Leak Free Connection

One of the major strengths of the O-ring side is the reduction of leakages it gives during connection.

Most times, metal to metal flanges when connected have a high risk of leakage. However, with the O-ring placed in-between the flange, there is less friction and risk of leakage is reduced too.

bottom of page